Steel wire rope sets of stainless steel rigging are divided into: composite wire rope sets of stainless steel rigging, inserted braided wire rope sets of stainless steel rigging, pressed steel wire rope sets of stainless steel rigging, single-end collar stainless steel rigging, pressed collar stainless steel rigging, and single limb collar stainless steel rigging , Two-limb set of stainless steel rigging, three-limb set of stainless steel rigging, four-limb set of stainless steel rigging, single-limb wire rope hook-type stainless steel rigging, two-limb wire rope hook-type stainless steel rigging, three-limb wire rope hook-type stainless steel rigging , Four-legged steel wire rope hook type complete set of stainless steel rigging, four-legged complete set of inserted braided stainless steel rigging.
预防措施使用完整的一套钢wire stainless steel rigging
1. Before using the complete set of steel wire stainless steel rigging, the working load and scope of application on the label must be clearly seen, and overloading is strictly prohibited.
2. When the complete set of steel wire stainless steel rigging is in use, directly hang the steel wire rigging into the center of the hook, not the tip of the hook.
3. When two steel wire slings are used together, directly hang the two steel wire slings into the double hooks, and each of the two steel wire slings is hung at the center of the symmetrical force of the double hooks; when the four steel wire slings are used together, two each When the steel wire rope sling is hung directly into the double hook, pay attention that the two steel wire slings in the hook cannot overlap and squeeze each other. The four steel wire slings should be symmetrical to the center of the hook.
4. When hoisting the complete set of steel wire stainless steel rigging, avoid the hoisting angle exceeding 60°.
5. Knotting of wire rope slings is prohibited, and direct contact between the wire ropes is forbidden. Shackles or rings should be added to separate them.
6. The complete set of steel wire and stainless steel rigging produces abnormal noise during load operation, so stop using it and wait for qualified personnel to check it before handling.
7. The complete set of steel wire stainless steel rigging should be as stable as possible during the hoisting process. Personnel are strictly prohibited from passing on the objects and no one is allowed to stand under the hoisting objects.
8. The stainless steel rigging that is pressed into a set of steel wires should avoid bending stress during transportation, installation and use, so as to avoid damage to the aluminum pipe, thread, joint or wire rope.