In the process of using the two-needle machine, we will often encounter the problem of disconnection, especially the two-needle machine will be disconnected. The manufacturer will solve this problem for you.
For older machines that have been in use for a long time, we should first check the thread passing parts for wire grooves that have been strained by the thread, such as the thread take-up rod hole, cloth feed hole, needle plate, etc., if there is a problem, we should repair it Or replace with new parts.
We can check if the movement of the needle and the feed dog match. The standard position of the movement of the needle and the feed dog is when the arrow on the lower shaft synchronous pulley is aligned with the engraved point of the machine case, the needle tip just drops to the plane of the throat plate, and the height of the feed dog is the same as the plane of the throat plate.
This synchronization position is very im创造。如果没有同步,您可以删除the timing belt, turn the timing belt pulley and the pulley to adjust to the standard position, and then replace the timing belt.
When the needle rises 2.5mm3mm from the bottom dead point, the hook tip should be at the center of the needle and 1.5mm above the needle hole. Adjust by adjusting the position of the hook and the up and down position of the needle clamp. When the needle enters the feeding tooth hole, the needle should be in the center of the feeding tooth hole. We should carefully check whether there are any scratches in the feed tooth hole and the needle board thread passing area, and ensure that the needle board thread passing gap and the shuttle inner core stopper maintain a 0.5mm 0.8mm gap. If the gap between the needle board threading gap and the shuttle core stop is too small, the thread will not pass smoothly, and the too large needle board will not hold the shuttle core.
When the double-needle machine is sewing thick materials, the needle will generate heat, and when it is relatively serious, it will emit smoke or burn off the suture. At this time, we can use silicone oil to cool the needle or reduce the sewing speed appropriately. In actual maintenance work, the operator should make corresponding adjustments to the relevant mechanism of the double needle machine according to different fabric and process requirements.
后 After adjusting the various mechanisms of the double needle machine, we should put on the suture correctly again according to the operating regulations, and keep the thread take-up spring on the thread clamp to be moderately elastic. Then, we put a piece of fabric under the presser foot and turn the pulley by hand to observe carefully whether the suture can smoothly rotate in the rotary hook.